Skip to main content
All CollectionsCue Lists
Cue List Settings
Cue List Settings
Updated over a year ago

The Cue List Properties window can be accessed by clicking on the Settings Button (Cogwheel) located in the lower right corner of the Cue List. It contains all the settings for the cue list.

List Name & List Number

Each cue list can be assigned a name and a list number. The name describes the list, while the list number is used for controlling specific lists via MIDI Show Control.

Midi Settings

To use Midi Show Control or custom midi triggers on each cue, a MIDI input device must be selected.
The input device can be selected from the drop-down menu in the Cue List Properties.

When List must be Armed to be triggered is checked, the Cue List will only respond to MIDI messages when the red Armed button is enabled.
The Enable Midi Show Control checkbox allows for the toggling of Midi Show Control message listening.
The Cue List Midi Settings are global settings shared by all cue lists in the project.

OSC Settings

The Enable OSC Triggers checkbox controls, if the individual, custom OSC triggers on each cue, should be enabled or not. Note that Global OSC messages, or OSC Controllers are still able to trigger the list using the global OSC commands.

OSC Control Settings

This will bring up the OSC Control settings window. This is a global setting and is equal to going to Controllers > OSC Options

Timecode Settings

Each cue in the cue list can be triggered by time code. To enable the time code input for a list, click the Enable Timecode Triggers button and select the audio input that is receiving the LTC Timecode signal.

Did this answer your question?