While the Cue Lists can be controlled through the built-in OSC commands, there may be instances where you need to trigger cues using a custom address. This could be due to a lack of control over the commands being sent out by the controlling device. By utilizing individual and customized OSC triggers, the cues can be bound to almost any incoming OSC command, regardless of the message format.

To enable the individual OSC triggers open the Cue List Settings panel and click on Enable OSC Triggers.

You must also set the OSC input port to be used. This is a shared setting with the global OSC commands.

Once this is set up, click on the cue you want to trigger.

Go to the Triggers Tab in the Cue editor, then click on Trigger By OSC

Next, type in the OSC address to be used as the trigger.