Note: You can only choose your auto-connect location if you have access to multiple Enclaves. If you only have access to a single Enclave, you will automatically connect to it by default.

Log in to your Dispel application, and tap on the "Settings" tab at the bottom.

On the top of the settings panel, you should see "Connect on Startup." Tap to open the Connect on Startup panel.

You should see a list of your Enclaves. Tap on the one you would like to set to be your auto-connect location. You should see a purple check mark next to the Enclave name. In the example below, "Remote Access Demo" has been selected. You should now see the name of you Enclave appear in grey on the left as well.

Now, you when you open the app, you will be automatically connected to this Enclave.

Note: This connects you to an Enclave automatically, but not a destination location yet. To set up auto-connect on startup directly to a facility, make sure to set your desired facility as a Favorite Location.

Log in to your Dispel application, and make sure the "Enclaves" tab is selected. You should be able to see all your Enclaves on the screen.

Connect to your location. Make sure you are fully connected by verifying there is a green dot next to the Enclave name on the left. In this example, we've connected to a facility in Remote Access Demo.

Tap "Set favorite."

You should see a purple star next to the location.

Now, when you connect to this Enclave, you will automatically be connected to this location as well.

Log in to your Dispel application, and tap on the "Settings" tab at the bottom.

Tap on "Reset All Settings."

Confirm by clicking "Reset."

Now, all of your favorites and auto-connect on starts will be set back to default.

Message us on the chat bubble on the bottom right of this page, or email us at hello@dispel.io. We always respond.