Check out guides on how to physically set up your Thiamis, and how to generally add a sensor in Environet.
Below you'll see the process step by step for the SoundPro series of sensors as well as tips for troubleshooting and understanding model specific features.
The Quest SoundPro requires the serial connector cable (TSI part number 053-729) which plugs into the auxiliary port and converts it to a RS-232 serial port.
Setup Instructions:
Connect a 12V power supply to the 3 pole Euroblock connector or 5V power supply to either of the USB ports.
Plug the adapter cable into the SoundPro's auxiliary serial port on the bottom.
Connect the other end of the cable directly to the Thiamis 1000's RS-232 port.
When using a splitter cable, note which sensor is connected to each letter port for configuring in Environet when Adding Sensors.
Errors
When the SoundPro is not reporting, check the configuration page or hover over the red status indicator for more information.
Timeout
The SoundPro has not responded to the requests made by the Thiamis and has timed out. It will continue to attempt communication but you can run through the general Troubleshooting Sensors steps to address common problems.
Tips on Specific Models:
SE / DL
Only A-weighted Lav, Leq, Lpk, Lmin, Lmax are supported.
Settings
Ensure your settings on the soundmeters are as follows to enable data output.
START menu > SETUP > COMM-SET:
USB: QSP/Serial
RS-232: Serial
Baud Rate 4800
Console Controls
You can change the measurement mode (SLM, 1/1, 1/3), filters and Session Time from the configuration page.
List of Supported Models:
Click on names for links to manufacturer user manuals.