Screw the lower part of the C-clamp until it is tight and secure. Make sure that both the top of the C-clamp and the underside are resting on flat surfaces.

Place the bottom of the mic arm inside the C-clamp, then tighten the screw. Twist the shock mount and adjust the side that has a small round hole upward.

Put the microphone on a shock mount. Then take the threaded ring out from the accessories bag, then twist it on the microphone.

Pull the rubber band on the back side of the pop filter and put it on the mic to reduce pops. Three adjustable thumb screws give the flexibility of position.