Skip to main content
All CollectionsSoil Sensor Help & FAQs
Soil Sensor Ground Installation
Soil Sensor Ground Installation

Proper installation of Spiio soil sensors ensures optimal data collection and accuracy. Follow these step-by-step instructions to install a sensor in the field.

L
Written by Lauren Hudson
Updated over 2 months ago

1. Identifying the Best Installation Location

  • Before installation, check cellular signal strength at the desired location.

  • Open the GreenCast Connect app.

  • Tap the Sensors button at the bottom of the screen.

  • Select Location Quality Test to assess signal strength.


2. Testing Signal Strength

  • Follow the on-screen animation to scan the sensor and read the signal strength.

  • Place the sensor horizontally on the ground in the chosen location.

  • Scan the white QR code label on the sensor.

  • Remove the magnet from the sensor and place it aside.

  • Wait for the app to display Waiting for sensor to test location quality.

  • The sensor will search for a signal (this may take up to 3 minutes).

  • A green light confirms a successful connection.

  • The Location Quality screen will display signal strength.

    • NOTE: A rating below FAIR is not recommended for below-ground installation.


3. Preparing for Installation

  • Reattach the magnet to the recessed portion of the sensor’s white top cap.

    • Leave the magnet on for at least 30 seconds to allow a full power-down cycle.

  • Gather installation tools (cup cutter, auger, or similar tools).

  • Cut two holes to prepare for sensor placement.

  • Create a guide hole (must be smaller than the sensor to prevent air gaps).


4. Installing the Sensor in the Ground

  • Insert the sensor into the guide hole horizontally in the direction of the white arrow.

  • Push the sensor firmly into the soil using hand force or a non-impact tool.

  • Keep the QR code label visible.

  • Leave the magnet on the sensor at this stage.


5. Registering the Sensor in the App


9. Confirming Successful Installation

  • After following How to Add A Sensor, the app will show Installation Successful!

  • Review the signal strength and first data readings for:

    • Moisture

    • Salinity

    • Temperature

  • Note that signal quality may slightly decrease once buried in soil.

  • Tap Finish Installation to complete the process.


10. Final Steps & Verification

  • Store the magnet safely in its original box (Do NOT place it back on the sensor).

  • Open the Sensors tab in the app.

  • Navigate to the Area where the sensor was installed.

  • Expand the sensor list to view real-time data and confirm successful transmission.


Installation Complete!

Your Spiio soil sensor is now installed, connected, and transmitting data.

Did this answer your question?