This article applies to VRIFY Present Beta. View legacy 360 Slide instructions at Create 360 Slides.
Overview
This article explains how to add a 360 Slide to your presentation, add an image, and set a transition viewpoint.
Once your 360 Slide is set up, you can enhance it with interactive Hotspots.
Note: Only files with Accepted status appear in the asset list when building a 360 Slide. If a photo is missing, check its status on the Files page. Learn more about your File Status.
Step by Step Instructions
Create a 360 Slide
Open your 3D Presentation
Click + Add Slide
Select 360
Select the Asset you want to add
Note: The list will be blank if there are no 360° images available in the asset files
Click Continue
A blank 360 slide will load.
Add a 360 Image
Click Edit 3D Slide
In the left side panel, open 360 Imagery
Select the image you want to use
Click the + to add the image
Set and Reset a Transition Viewpoint
The Transition Viewpoint determines where the camera moves after the slide loads. Use this to guide attention to a specific feature within the image.
In the Objects in Model panel, open 360 Imagery
Select your image
Click the blue icon beside Set Transition Viewpoint
Set your desired viewpoint:
Right-click and drag to rotate the image
Use your mouse wheel to zoom in or out
Once you’ve chosen an ideal position, click Save Viewpoint
When the slide loads, the view will move smoothly to the saved transition point.
To reset a viewpoint, open the Transition Viewpoint panel and select Reset.
Add Hotspots to Your 360 Slide
Hotspots are interactive points you can add to a 360 Slide. Use them to mark locations, surface additional information, or link to other 360 images.
Read Add Hotspots to a 360 Slide for step by step instructions.
Learn More
Still Have Questions?
Reach out to your dedicated VRIFY contact or email support@vrify.com for more information.