Required Tools:
Number one Phillips screwdriver
Allen wrench set
Pliers
Dry towel
Locate the water filter
The easiest way to locate the water filter is to remove the front bottom panel, which is held by magnets, as well as the front top panel. You will need a Phillips screwdriver to remove the front top panel.
Before looking inside of your Hydropack, identify the filtered water outlet.
Replacing the Water Filter
Turn off the machine by flipping the breakers from right to left, waiting two seconds between each flip.
Remove panels blocking access to the water filter using your Phillips screwdriver or Allen wrench.
Place a dry towel at the base of the filter to catch potential water spillage.
Locate the water filter within the machine.
Twist off the nut holding the filter clasp by hand. If tight, use pliers to loosen and remove it.
Remove the clasp and take out the old filter.
Place the new filter into the casing.
Replace the filter clasp.
Securely fasten the nut, ensuring it is tight and properly aligned.
Replace any removed panels.
Turn the machine back on by flipping the breakers.
Note: Consult your specific Hydropack model's manual for precise instructions.