You can check what version you are using by connecting your Fieldy and going into Device Settings.
Version 2.3.0 and later
With 2.3.0 we introduced support for Offline Storage.
Button gestures
Single Click
Single white blink - Fieldy is connected.
Three white blinks - Fieldy is disconnected. Open the app to connect again.
3 second hold will turn on or turn off
LED indicators
Blue
Fieldy is in a pairing mode. Use Fieldy App to connect. If not paired with your phone, blue light basically indicates a disconnected state.
White (static)
Fieldy is on and operational. It's either connected and transcribing in real-time or writing to Offline Storage in order to sync later.
Note: Offline Storage is only available, if your Fieldy is properly paired to your phone. You can check your pair status in device settings.
In the case where Offline Storage is not activated use a Single Click to check if Fieldy is connected and transcribing.
White (blinking)
Fieldy is either muted or out of Offline Storage. Open the app to unmute
Red
Fieldy is running out of battery. Charge it to resolve.
Resetting your device
Power reset
10 second long press will power reset Fieldy. This is useful if Fieldy gets stuck in some weird state.
Factory reset
A single click followed by an immediate 10 second long press will factory reset. This should be used as a last resort, as Fieldy will wipe Bluetooth pairing information with your phone. This means to connect to it again, you will have to forget Fieldy from your device's bluetooth settings.
Version between 1.0.8 and 2.0.4
Normal Operation Indicators
White (steady):
Device is connected and battery level is above 5%.
White (blinking/breathing):
Device is ready to connect and battery is above 5%.
Red (steady):
Device is connected, but battery level is below 5%.
Red (blinking/breathing):
Device is ready to connect, with battery below 5%.
Button Interactions and LED Responses
On Single Click:
Green: Battery is above 15%.
Orange: Battery is at a medium level.
Red: Battery is below 5%.
Red blinking 3 times, then no light:
The device is fully discharged and entering sleep mode.
On Long Press (1 second):
No light: Device is in sleep mode or turned off.
On Very Long Press (10 seconds):
Firmware v1.0.4+:
Red LED blinks 4 times – indicates the device was power-cycled.
Firmware v1.0.8+:
Red, Green, Blue, White – each blinks twice – confirms the device was power-cycled.
Error Indicators
Red (blinking rapidly):
Firmware update failed or is incomplete.
Purple (Blue steady + Red blinking rapidly):
Indicates a critical firmware issue.
Need Help?
If your Compass device shows any other color or combination not listed above, or if the LED behavior doesn’t match the descriptions, please contact our support team for more assistance.