Skip to main content
All CollectionsHandy
Using the buttons
Using the buttons

Guide for explaining what each button does.

Updated over 2 weeks ago

image of the button at the top of the handy

ON button

Click:
While the device is in manual mode (green LED), this will start and stop the device.

image of the up and down buttons on the handy

UP & DOWN button

Click:
Increases and decreases the stroke length. The LED will flash red as soon as the minimum or maximum length have been reached.

Hold:

Adjusts the stroke zone. Hold the UP button to make the device stroke closer to the top. Hold the DOWN button to reset it.

Both of the adjustments can be made in manual mode (green LED) and while the device is synchronizing to videos, etc.

image of the left and right buttons on the handy

LEFT & RIGHT button

Click:
While the device is in manual mode (green LED), this will decrease and increase the speed of the strokes.

The last button, called "Action" is used to swap modes in each Firmware but the behavior changes between versions. As such, let's take a look at how it behaves between versions.

Firmware 3

image of the wifi button on the handy, right above the LED

Action button

Click:
While the device is in manual mode (green LED), this will put the device into online mode (magenta LED).

Hod:

While the device is in manual mode (green LED), this will put the device into Bluetooth (blue LED).

Firmware 4

image of the wifi button on the handy, right above the LED

Action button

Click:

While the device is in Bluetooth mode (green LED), this will put the device into online mode (magenta LED) or Blueetooth + Wi-Fi mode (magenta and blue LED)

While holding UP, Hold:

While the device is in Bluetooth (green LED), this will put the device into Legacy Bluetooth Mode (Cyan LED).

More information about this mode can be found here.

Did this answer your question?