The silicon ring, or "blocker", is a spare part we're currently sending to users who struggle with Perifit+ positioning and stability during training.
2 types of blockers exist:
Removable blocker or blocker as a spare part. This blocker is meant to be set directly on the tail of Perifit+ and can be removed
Screwable blocker. This blocker is fixed on the tail of the Perifit+ and cannot be removed.
Removable blocker
The removable blocker can easily be assembled onto the tail of your Perifit+ to keep it in place during your training sessions.
You can use your Perifit+ without it; however, consider using this silicon ring if:
you're experiencing difficulties with calibration during a session;
you're experiencing important contraction quality or strength variations;
you feel that the Perifit+ is moving inside your vagina during your training;
Here is a step-by-step instructions on how to place it properly:
Insert the silicone ring (blocker) on the tail so that the lotus faces upwards, towards the part of the tail furthest from the Perifit.
Push the silicon ring all the way on the tail. Slide it as close as possible to the lower pebble-shaped sensor.
Finally, check that the ring slot is fully inserted into the tail
Attached is a short video if you're struggling to visualise what we describe.
Now that it's set up, you can:
Insert Perifit+ so that both pebble-shaped sensors are inside the vagina, with the lowest one on the probe near the vaginal entrance.
Once inserted, the silicon ring (blocker) should be snugged between your labia, meaning it's inserted as far as possible without entering the vagina.
Just so you know, depending on your anatomy, the exact placement of the ring on the tail can vary.
Based on that, you can adjust the silicon ring and see what position gets you the best results.
To take the silicon ring (blocker) out, just:
Take out Perifit+ by pulling gently on the tail
Gently take out the silicon ring from the tail
⚠️ Unscrew the ring from the tail gently and avoid pulling on the ring too hard.
If you have any questions, please don’t hesitate to reach out to our support team from within the app.
Screwable blocker
The screwable blocker is already assembled onto the tail of your Perifit+ to keep it in place during your training sessions. It's fixed and cannot be removed.
⚠️ Do not try to remove it as it might damage the silicon.
To insert Perifit+, you can:
Insert Perifit+ so that both pebble-shaped sensors are inside the vagina, with the lowest one on the probe near the vaginal entrance.
Once inserted, the silicon ring (blocker) should be snugged between your labia, meaning it's inserted as far as possible without entering the vagina.
To take Perifit+ out, just pull gently on the tail until the device is out of your vagina.
If you have any questions, please don’t hesitate to reach out to our support team from within the app.