Skip to main content

Hydropixel: How to Replace the Power Drive Board

Updated this week

Replacing the power drive board on your Hydropixel requires careful attention to detail and proper safety precautions. Before beginning, always consult with the Aquaria team to ensure you don't void your warranty.

Step-by-Step Replacement Guide:

  1. Preparation

    • Ensure the Hydropixel is completely off and unplugged

    • Gather a Phillips #1 screwdriver

  2. Wire Removal

    • Locate the five vertical screw connectors on the right-hand side

    • Carefully unscrew and remove the wires

    • Take careful note of each wire's original position

  3. Board Removal

    • Identify two securing screws: one on the lower right, one on the upper left

    • Unscrew these screws to remove the existing power drive board

  4. Installation

    • Place the new power drive board in position

    • Hand-hold the board while replacing the two securing screws

    • Reconnect the five wires to their original positions, ensuring secure connections

  5. Final Checks

    • Close the side panel

    • Plug in the Hydropixel

    • Switch on the machine and verify proper operation

Always prioritize safety and manufacturer guidelines when performing equipment maintenance.

Did this answer your question?