With the Cuez Gateway, you can easily select which of your Blocks you want to see on the 3rd party prompting software that you connected via the Gateway. In the same process, you can also select whether or not you want to see the 'badge' of these Blocks, as these can be helpful, or take up space that you want to save.

First, make sure to select an Episode in the Gateway to open it. If the connection with your 3rd party prompting software was correctly set up, this Episode will then load in your prompting software as well.

Next, on the right hand side of the loaded Episode in the Gateway application, a panel is shown where you can 'Set Block visibility'.

Using the eye-icons (1) you can select or deselect the Blocks depending on whether or not you want them to be shown in your prompting software. When (de)selecting, the Episode will be reloaded in the prompting software to reflect the changes, as shown in the example below with Cuez Gateway and WinPlus-IP.

In a similar way, using the 'T' icons at the back of the Blocks, you can decide whether or not the Block's badge should be shown. A Block's badge indicates which type of Block it is, such as 'Clip', 'Prompter', and so on.