🔧 Setup & Pairing Instructions
1. Initial Setup
Unbox and Remove Insulating Film: Before first use, remove any insulating film from the transmitters (TX) and receiver (RX).
Charging: Place the TX and RX units into the charging case to ensure they are fully charged.
Automatic Power On: Removing the TX and RX from the charging case will automatically power them on.
Automatic Pairing: The TX and RX are pre-paired at the factory. Upon powering on, they should automatically connect.
Powering On/Off:
Automatic Power: Removing the transmitters (TX) and receiver (RX) from the charging case powers them on automatically. Placing them back turns them off.
Manual Power: Press and hold the yellow button on the TX or the upper power button on the RX for 3 seconds to turn them on or off.
NOTE: When removed from the box or manually powered on, the TX and RX will flash blue while waiting for the other to be powered and paired. When they are solid blue, they are paired and ready for use.LED Indicators:
Flashing Blue: Device is on but not yet paired.
Solid Blue: Device is paired and ready for use.
Solid Green: Noise cancellation is active.
Flashing Red: Low battery warning.
Solid Amber Charging in progress.
Solid Green (while charging): Fully charged.
2. Manual Pairing (If Needed)
If the devices do not pair automatically:
Transmitter (TX):
Ensure the TX is powered off.
Press and hold the yellow button on the TX for 6 seconds until the blue light flashes rapidly.
Receiver (RX):
Ensure the RX is powered on.
Press and hold the pairing button on the RX for 3 seconds until the blue light flashes rapidly.
Once both devices are in pairing mode, they should connect automatically
3. Connecting to Devices
Computers:
Connect the RX to your computer via USB-C.
Select "Lark M2" as the input device in your computer's audio settings.
Here are some common troubleshooting steps for the Hollyland Lark M2 wireless microphone system, especially if you're facing pairing, audio, or connectivity issues:
1. Check Power and Connections
Ensure both the transmitter and receiver are fully charged.
Confirm that all devices are powered on and properly connected.
Use the original USB-C cables for charging and data transfer.
2. Reset the System
If the devices aren’t pairing or behaving erratically, try a reset:
Press and hold the pairing button on both the transmitter and receiver for about 10 seconds until the LED indicators flash, then release.
This will restore factory settings and often resolves pairing glitches.
3. Re-Pair Devices
Place the transmitter and receiver close together.
Press the pairing button on both units simultaneously until the LEDs blink rapidly.
Wait for the lights to turn solid, indicating a successful connection.
4. Audio Issues
No Sound: Check that the receiver is properly connected to your camera or phone and that the input is selected correctly.
Distorted Audio: Lower the gain on the transmitter or adjust the input level on your recording device.
Low Volume: Make sure the mic isn’t obstructed and that the receiver’s output level is set appropriately.
5. Firmware and Compatibility
Visit Hollyland’s official site to check for firmware updates.
Ensure your recording device supports external microphones via USB-C or 3.5mm input.
🔄 Additional Support for Hollyland Lark Mics
TEL: +1 929-605-6085(USA,Canada)
9:00-17:00(PST) Mon-Fri
Address: Los Angeles, USA
Email: support.us@hollyland.com
