How can I tell if the boom arm that comes with the AM6T (mic with boom arm version) fits my desk?
There are some easy ways to check if AM6T fits your desk.
1. Reach the desk clamp entirely into the desk edge with 1.7 inches(40 mm). The width of the desk edge you used should be less than 2.1 inches (55 mm).
2. Use a bank card to check it - 3.3 inches (85.5mm) in length and 2.1 inches (55mm) in width.
3. The width of your desk edge had better to less than the width of the Bank Card.
Can it be attached to a boom arm?
The thread size is standard 5/8" and 3/8" for the AM6 yoke mount. So NO adapter is needed, just screw the mic in video below of using it with the FIFINE BM88 low-profile microphone stand is for your reference.
Counterclockwise, remove the mic from the base stand.
Lose the knob and put the microphone into the 1/4" to 3/8 adapter and tighten it.
Clockwise, screw the knob to firmly tighten.
Install a 3/8" to 5/8" adapter into the boom arm.
Lose the knob and put the microphone into the 3/8" to 5/8" adapter and tighten it.
Clockwise, screw the knob to firmly tighten. Screw the thumbscrew to adjust the angle of the mic.
Loosen the knob to adjust the suitable angle and height of the mic.
How to set it up through the USB?
The package comes with a Type-C (microphone end) to Type-A (computer end) audio cable. For a USB connection, you just need to take one end of the cable to the microphone, and the other end to your PC, laptop, or Mac that has a Type-A port.
How can I properly use the chat mix feature?
After connecting it properly with your computer as the instruction from above Q&A and plugging your headset/headphone into the 3.5mm jack at the bottom of the mic, you need to click into the setting of your game to make the "fifine game" as the default out and into Discord or any party chat apps to assign the "fifine chat" to the default output device. The exact steps can be found in the video below.
Connect the headphone and the microphone
Turn up or down the monitoring volume.
Set your Game Application
Counter-Strike 2: Click “Audio” of your game and then choose "Headphones (fifine Game)” as the default output device. Choose "Microphone (fifine Chat)" as the default input device.
Discord: “User Settings” - “Voice&Video” - Choose "Microphone (fifine Chat)" as default input device
If you turn left, the chat application sound will decrease, and the game application sound volume will increase. Turning right will result in the opposite.
How to run an audio test on Windows and Mac to make sure it is working after the connection?
Connecting through the USB with Windows or Mac, in both cases, you have to go to the audio settings of the computer system to check if the "fifine chat" driver is successfully installed, if the level is turned up to a proper point, and if the meter moves when you talk to the FIFINE AM6 microphone.