Before you begin, make sure your printer is connected and ready, and that you are using the supported DYMO 30270 continuous labels.
1. Download and Install QZ Tray, then Open Printer Settings in AccelerList
Before proceeding, make sure you download and install QZ Tray.
To install QZ Tray, kindly check this guide:
Once installed, navigate to:
Settings → Printer → MF Location Tickets
2. Configure Your Printer Settings in AccelerList
Make sure your settings match the recommended configuration below:
Active Printer: Dymo
Orientation: Landscape
Label Type: Dymo 30270 | 2.125 x 3.5 (Continuous)
✅ Click Save Changes after updating your settings
3. Important: Supported Label Type
For MF ticket printing, we only support:
DYMO 30270 Continuous Labels
⚠️ Using other label types may cause:
Misaligned prints
Incorrect sizing
Printing errors
4. Verify Printer Settings in Windows
On your computer:
Open Control Panel → Devices and Printers
Right-click your DYMO printer → Click Printing Preferences
Set the following:
Label Type: Continuous Wide
Resolution: 300 x 600 dpi (recommended)
⚠️ This step is very important — incorrect label type will cause formatting issues.
5. (Optional) Configure Labels in DYMO Connect App
If your labels are still not aligned properly:
For DYMO Printers (Using DYMO Connect App)
Step 1: Open DYMO Connect
Launch the DYMO Connect app on your computer
Step 2: Choose a Blank Label Layout
Select a blank label template
Step 3: Open Label Properties
Right-click the label, or
Open the Properties panel
Step 4: Set Label Dimensions
Enter the correct size for 30270 continuous labels
Step 5: Adjust Margins for Elements
Double-click text/barcode
Open Properties or Advanced
Adjust margins as needed
Step 6: Adjust Overall Margins
Go to Page Setup or Layout
Update full label margins
Step 7: Save and Test Print
Save settings and print a test label
6. Print a Test Label in AccelerList
After completing all setup steps:
Click Print Test Label
Confirm the label prints clearly and is properly aligned
Quick Reminder ✅
For best results:
Use DYMO 30270 Continuous Labels only
Set printer to Continuous Wide in Windows
Use 300 x 600 dpi resolution
Keep orientation set to Landscape
Ensure AccelerList and printer settings match exactly