MF ticketing uses continuous labels, so correct setup is important to prevent issues like misalignment or continuous feeding.
1. Install and Run QZ Tray (Required)
Before setting up your printer, make sure QZ Tray is installed and running.
Install QZ Tray
Open it and make sure it is running in the system tray (bottom-right corner)
Refresh AccelerList after opening
👉 If QZ Tray is not running, printing will not work
2. Open AccelerList in Chrome (Recommended)
Close the AccelerList desktop app (if open)
Open Google Chrome
Log in to AccelerList
3. Open Printer Settings in AccelerList
Navigate to:
Settings → Printer → MF Ticketing
4. Configure Printer Settings in AccelerList
Set the following:
Active Printer: Brother QL-800 / QL-700
Printer Driver Config: Select available Brother config
Orientation: Portrait
Label Type: Dymo 30270 (Continuous)
✅ Click Save Changes
5. Set Printer as Default (Windows)
Go to Control Panel → Devices and Printers
Right-click your Brother printer
Click Set as Default Printer
6. Configure Continuous Label in Printer Preferences (Important)
Right-click your printer → Printing Preferences
Set the following:
Label Type / Paper Type: Continuous
Paper Size: Continuous Wide (or equivalent)
Ensure correct width for your label roll
⚠️ Important:
Continuous label must be enabled
Incorrect setup may cause:
Labels not stopping correctly
Continuous feeding
Misaligned prints
7. Connect AccelerList to QZ Tray
In AccelerList, open printer settings
Select your printer
When prompted, click Allow / Trust
8. Print a Test Label
Click Print Test Label in AccelerList
Confirm:
Labels stop correctly
Alignment is correct
No continuous feed issues
9. Troubleshooting (If Test Print Fails)
If printing does not work:
Restart QZ Tray and refresh AccelerList
Confirm printer is still set as default
Recheck printer preferences (continuous enabled)
Restart your computer if needed
Quick Reminder ✅
For best results:
Use Dymo 30270 continuous labels (or matching size)
Set Continuous Wide in printer preferences
Ensure QZ Tray is running
Use Google Chrome
Set printer as default.