If you're using a DYMO printer on macOS, especially after system updates, some label settings may not appear correctly. This guide ensures your printer is configured properly for accurate and consistent MF ticket printing.
1. Install QZ Tray (Required)
Before setting up your printer in AccelerList, make sure QZ Tray is installed and running.
If you need help installing it, kindly check the guide below:
2. Configure Printer Settings in AccelerList
Go to:
Settings → Printer → MF Location Tickets
Set the following:
Active Printer: Dymo
Orientation: Landscape
Label Type: Dymo 30270 | 2.125 x 3.5 (Continuous)
✅ Click Save Changes
3. Important: Supported Label Type
For MF ticketing, we only support:
DYMO 30270 Continuous Labels
⚠️ Using other label types may cause:
Misaligned prints
Incorrect formatting
Printing errors
4. Open Terminal
Go to Applications → Utilities → Terminal
5. Enable the CUPS Web Interface
In Terminal, enter:
sudo cupsctl WebInterface=yes
Press Enter → enter your Mac password → press Enter again
6. Open the CUPS Printer Page
Open your browser and go to:
http://localhost:631
7. Select Your DYMO Printer
Click Printers tab
Select your DYMO printer
8. Configure Printer Options (VERY IMPORTANT)
Click Administration
Select Set Default Options
Set the following:
Media Size / Paper Size: Match 30270 (or custom 2.125" x 3.5)
Media Type / Label Type: Continuous Wide (Required)
Orientation: Landscape
⚠️ Make sure Continuous Wide is enabled — this is required for MF ticket printing.
9. Save the Settings
Click Set Default Options / Save
Enter your Mac username and password if prompted
10. Verify Printer Setup
Go to:
System Settings → Printers & Scanners
Confirm your DYMO printer shows “Ready”
11. Test Print in AccelerList
Go back to AccelerList
Click Print Test Label
Confirm alignment and clarity
Quick Reminder ✅
For best results:
Use DYMO printer (LW 450 or similar)
Use DYMO 30270 Continuous Labels ONLY
Enable Continuous Wide in CUPS
Keep orientation set to Landscape
Ensure AccelerList and CUPS settings match exactly