Since AccelerList does not directly support all printer brands, this setup includes a simple workaround (renaming your printer to Dymo) so it can be recognized and used properly.
1. Install and Run QZ Tray (Required)
Before setting up your printer, make sure QZ Tray is installed and running.
QZ Tray allows AccelerList to communicate with your printer.
Download and install QZ Tray. Kindly check the icon below to guide you about QZ Tray
Open QZ Tray
Make sure it is running in your system tray (near the clock)
👉 If QZ Tray is not running, printing will not work
2. Confirm Your Printer Works in Windows
Before connecting to AccelerList:
Go to Control Panel → Devices and Printers
Right-click your printer → Printer Properties
Click Print Test Page
✅ Only proceed if the printer works correctly
3. Rename Printer to “Dymo” (Required Workaround)
To allow AccelerList to detect your off-brand printer:
Go to Devices and Printers
Right-click your printer → Printer Properties
Rename it to: Dymo
Click Apply
Right-click again → Set as Default Printer
👉 This step is required for off-brand printers to work with AccelerList
4. Configure Label Size in Printer Preferences
Open Printing Preferences and set the correct label type.
✅ Supported Label (MF Ticketing):
Dymo 30270 (Continuous label)
Or any label size that matches this format
⚠️ Important:
Make sure “Continuous Wide” is enabled in your printer settings
Using incorrect settings may cause:
Continuous feed issues
Misaligned prints
Labels not stopping correctly
5. Allow AccelerList in QZ Tray
Open QZ Tray from the system tray
Click Site Manager
Make sure AccelerList is set to Allowed / Trusted
6. Configure Printer in AccelerList
Go to:
Settings → Printer → MF Ticketing
Set:
Active Printer: Dymo (the renamed printer)
Label Type: Dymo 30270 (Continuous)
Orientation: Adjust if needed
✅ Click Save Changes
7. Run a Test Print
Click Print Test Label in AccelerList
Check:
Label spacing
Alignment
Proper stopping/cutting
8. Restart If Needed
If printing does not work:
Restart your printer
Restart your computer
Reopen QZ Tray
Refresh AccelerList
Quick Reminder ✅
For best results:
QZ Tray must be running
Rename your printer to Dymo
Select Dymo as the active printer in AccelerList
Use Dymo 30270 continuous labels (or matching size)
Enable Continuous Wide in printer settings