Since AccelerList does not directly support all printer brands, this setup provides a workaround so your printer can function properly using QZ Tray.
1. Install and Run QZ Tray (Required)
Before anything else, make sure QZ Tray is installed and running.
QZ Tray is required for AccelerList to communicate with your printer.
Download and install QZ Tray. Click the button below to guide you about QZ Tray
Open QZ Tray
Confirm it is running in the system tray (near the clock)
👉 If QZ Tray is not running, printing will not work
2. Confirm Your Printer Works in Windows
Before connecting to AccelerList:
Go to Control Panel → Devices and Printers
Right-click your printer → Printer Properties
Click Print Test Page
✅ Only continue if the printer works properly in Windows
3. Rename Printer to “Dymo” (Important Workaround)
Since off-brand printers are not natively supported:
Go to Devices and Printers
Right-click your printer → Printer Properties
Rename it to: Dymo
Click Apply
Right-click again → Set as Default Printer
This allows AccelerList to recognize your printer correctly
4. Set the Correct Label Size in Printer Preferences
Open Printing Preferences
Select the correct label size
✅ Supported Label Sizes (SKU + FNSKU Labels Only):
30336
30252
30334
Or any label that matches these dimensions
⚠️ Using unsupported sizes may cause:
Misaligned labels
Incorrect scaling
Printing errors
5. Allow AccelerList in QZ Tray
Open QZ Tray from the system tray
Click Site Manager
Make sure AccelerList is Allowed / Trusted
This ensures your browser can send print commands
6. Configure Printer in AccelerList
Go to:
Settings → Printer → SKU + FNSKU Labels
Set the following:
Active Printer: Dymo (renamed printer)
Label Type: Match your label (30336, 30252, or 30334)
Orientation: Adjust based on your label
✅ Click Save Changes
7. Run a Test Print
Click Print Test Label in AccelerList
Check:
Alignment
Size
Clarity
8. Restart If Needed
If printing does not work:
Restart your printer
Restart your computer
Reopen QZ Tray
Refresh AccelerList
Quick Reminder ✅
For best results:
This setup is for SKU + FNSKU labels only
Install and run QZ Tray
Rename printer to Dymo
Use supported label sizes (30336, 30252, 30334)
Ensure printer works in Windows first
Allow AccelerList in QZ Tray
Match printer settings with AccelerList
If everything is set correctly, your off-brand printer should now work smoothly for SKU + FNSKU label printing in AccelerList 👍