MF ticketing uses continuous labels, so it’s important to configure both your printer and AccelerList correctly to avoid issues like misalignment, continuous feeding, or incorrect label sizing. Follow the steps below to ensure everything is set up properly.
1. Install and Run QZ Tray (Required)
Before setting up your printer, make sure QZ Tray is installed and running.
QZ Tray allows AccelerList to communicate with your printer.
Download and install QZ Tray. Please click the icon below to guide you about QZ Tray
Open QZ Tray
Make sure it is running in your system tray (near the clock)
👉 If QZ Tray is not running, printing will not work
2. Confirm Your Printer Works in Windows
Before connecting to AccelerList:
Go to Control Panel → Devices and Printers
Right-click your Zebra printer → Printer Properties
Click Print Test Page
✅ Only proceed if the printer works correctly
3. Set Printer as Default
Go to Devices and Printers
Right-click your Zebra printer
Click Set as Default Printer
4. Configure Label Size in Printer Preferences
Open Printing Preferences and set the correct label type.
✅ Supported Label (MF Ticketing):
Dymo 30270 (Continuous label)
Or any label size that matches this format
⚠️ Important:
Make sure “Continuous Wide” is selected under your printer’s label/type settings
Using incorrect settings may cause:
Continuous feed issues
Misaligned prints
Labels not stopping correctly
5. Allow AccelerList in QZ Tray
Open QZ Tray from the system tray
Click Site Manager
Make sure AccelerList is set to Allowed / Trusted
6. Configure Printer in AccelerList
Go to:
Settings → Printer → MF Ticketing
Set:
Active Printer: Zebra printer
Label Type: Dymo 30270 (Continuous)
Orientation: Adjust if needed
✅ Click Save Changes
7. Run a Test Print
Click Print Test Label in AccelerList
Check:
Label spacing
Alignment
Proper cutting/stopping
8. Restart If Needed
If printing does not work:
Restart your printer
Restart your computer
Reopen QZ Tray
Refresh AccelerList
Quick Reminder ✅
For best results:
QZ Tray must be running
Use Dymo 30270 continuous labels (or matching size)
Enable Continuous Wide in printer settings
Set printer as default