Installation Guide
Step 1.
Unscrew the Gobbler by holding the knurled end and turning the Hexagonal turn style wheel anti-clock wise. Taking out all the components of making sure to account for all 5 pieces including the rubber gasket.
Step 2.
Using the Provided Torx Key, Unscrew the Sling stud Pin Anti-clockwise and remove.
Step 3.
Place back over the Sling Stud and align the sling stud and adapter eyelets with the Shotgun Sling stud being in the Middle and then Thread the Sling stud pin back through making sure the male and female threads are aligned as one side of the Stainless steel housing is threadless.
Step 4.
Re-tighten by turning clockwise, only tighten till flush if you run your finger around and don't have any protrusion. If protruding, the next step will struggle to thread on.
Then place a rubber gasket over the Stainless steel housing to protect the magazine end Cap. Finally place the end knurled Tensioning Ring over the main housing with the flared end facing towards the trigger well and manoeuvre it down to the thread then carefully turn clockwise with your fingers until it is snug with the rubber gasket.
Note: The adapter is designed to be hand-tightened only onto the magazine cap. This ensures a secure fit while reducing the risk of the magazine cap loosening or unintentionally unscrewing during use.
Step 5.
Place the MagnaSwitch™ housing over the Stainless Steel housing and make sure it sits vertically to the barrel. Place the turn style wheel over the thread and gently turn clockwise until the Threads engage then snug down till it locks into place with the MagnaSwitch™ spigot section.
Replace your sling on the Sling stud on the front of the gobbler and Your Ready to Hunt with any of our MagnaSwitch™ family but we highly recommend you to pair the Gobbler with the SpringBok Bipod and SpringBok Tripod.