Skip to main content

Hydropixel: How to Replace the Top Tank UV Light

UV Light Replacement Guide for Aquaria Hydropixel Top Tank

Updated this week

Tools Needed:

  • #1 Phillips screwdriver

Step-by-Step Instructions:

  1. Preparation

    • Remove the upper back panel of the Hydropixel

    • Set panel aside

  2. Initial Disassembly

    • Locate two screws at top left and right corners

    • Remove these screws

    • Remove any bungees or C-clamps blocking access

    • Shut off Hydropixel if needed

    • Remove tubing if necessary

  3. UV Light Replacement

    • Locate the white square in the middle of the top tank

    • Remove four screws in this area

    • Carefully pull out the existing UV light

    • Hold the white connection (not wires) when disconnecting

    • Disconnect old UV light from four-prong connection

    • Connect new UV bulb to four-prong connection

    • Gently slide new UV light back into casing

    • Ensure wires are seated in the lip/dip

  4. Reassembly

    • Replace four screws

    • Reattach any removed tubing

    • Replace bungees

    • Reattach top lid

    • Replace left and right screws

    • Reinstall back top panel

Caution: Handle UV light carefully as it is encased in glass.

Did this answer your question?