Follow the steps below to connect your computer to RoboCap Wifi and access RoboCap Control Center.
Step 1: Power On RoboCap
Connect RoboCap to your power bank.
Toggle the Power Switch to ON.
Wait approximately 5–10 seconds.
When the indicator light turns red, RoboCap is powered on and ready.
Step 2: Connect to the RoboCap Wi-Fi
On your computer or mobile device:
Open your Wi-Fi settings.
Find the Wi-Fi network starting with
Robocap_. For example:Robocap_2cfConnect using the default password:
12345678
Note: Your computer or mobile device must be connected to the RoboCap Wi-Fi to access the RoboCap Control Center.
Step 3: Open the RoboCap Control Center
Once your computer or mobile device is connected to the RoboCap Wi-Fi:
Open a browser.
Enter
192.168.11.1in the browser address bar.The RoboCap Control Center will open.
If the page does not open, check that your computer or mobile device is still connected to the RoboCap Wi-Fi.
What You Can Do in the RoboCap Control Center
Once you've accessed the RoboCap Control Center, you can use it to manage your RoboCap settings and connected devices.
Unpair a RoboWrist — Remove RoboWrists that are connected to your RoboCap.
Pair a RoboWrist — Connect a RoboWrist to your RoboCap.
Adjust Camera Settings — Change camera settings to help reduce issues such as light flickering.Factory Reset RoboCap — Clear stored data and reset your RoboCap.
Check Device Information — View information about your RoboCap, including its software version and storage.