Follow the steps below to remove a RoboWrist that is currently paired with your RoboCap.
Before starting, make sure you know the device ID of the RoboWrist you want to unpair. This helps prevent you from accidentally removing the wrong RoboWrist.
Not sure which device ID belongs to your RoboWrist? Follow our How to Find Your RoboWrist Device ID guide.
Step 1: Power On RoboCap
Connect RoboCap to your power bank.
Toggle the Power Switch to ON.
Wait approximately 5–10 seconds.
When the indicator light turns red, RoboCap is powered on and ready.
Step 2: Connect to the RoboCap Wi-Fi
On your computer or mobile device:
Open your Wi-Fi settings.
Find the Wi-Fi network starting with
Robocap_. For example:Robocap_2cfConnect using the default password:
12345678
After connecting, the RoboCap Control Center will open.
Step 3: Open Device Pairing
In the RoboCap Control Center, navigate to Device Pairing.
Scroll down to the Device Layout section.
Here, you'll see the RoboWrists currently paired with your RoboCap, including their device IDs and connection status.
Step 4: Unpair the RoboWrist
Find the device ID of the RoboWrist you want to remove.
Confirm that you've selected the correct RoboWrist.
Click Unpair next to the device.
A confirmation message will appear. Click OK to proceed.
After a few seconds, the RoboWrist will disappear from the paired device list. This confirms that it has been successfully unpaired from your RoboCap.