Skip to main content

Solar Settings

Choose existing buildings, the study area, shading, and accuracy

Written by Holly Conrad Smith

Solar settings decide what Solar counts as already on the site, what shades it, and how fine the results are. Set them once for a project so everyone on your team gets the same answer. To open them, click the settings button at the top right of the Solar app.

Existing and demolished

Solar treats every geometry you draw as proposed, unless you mark it. The Existing and demolished tab marks the usages and scenarios that are buildings already on the site.

  • Existing: buildings that stay on the site. Their shadows count both before and after your proposal.

  • Demolished: buildings your proposal removes. Their shadows count before your proposal and not after.

  1. Click the Existing box and pick the usages or scenarios of buildings that stay.

  2. Click the Demolished box and pick the usages or scenarios of buildings your proposal removes.

Existing and demolished buildings cast shadows even when their scenario is hidden on the map. Compare mode and the Lost colors in Sun hours use these settings. Learn more about scenarios and usages.

Demolish masked 3D Buildings

When Demolish masked 3D Buildings is on, buildings on the 3D Buildings layer inside your site boundary that the layer's filters hide count as demolished. Turn it off to leave those buildings out of Solar. It is on by default. Learn how to clear existing 3D buildings from your site.

Rules

The Rules tab holds the Baseline and your solar rules. Learn how to check open space with solar rules.

Calculation

The Calculation tab sets the area Solar measures, what casts shade, and how accurate Sun hours is. Area and Shading are saved with the project, so everyone gets the same results. Accuracy applies only in your browser.

Area

Clip to boundary measures sun hours inside your project boundary only. Turn it off to also measure the ground within 100 m around the boundary. It needs a polygon boundary and is on by default.

Shading

  • Shade from terrain: hills and slopes cast shadows. It needs 3D terrain turned on in the Terrain app.

  • Shade from 3D Buildings: buildings on the 3D Buildings layer cast shadows. It needs the 3D Buildings layer shown on the map.

Both are on by default.

Accuracy

  • Time step: how often Sun hours checks the sun, from 1 to 60 minutes. The default is 15 minutes. A shorter step is more accurate and takes longer.

  • Facade segment: the longest piece Giraffe splits each facade into. Each piece gets one result. Shorter pieces show more detail and take longer. The default is 2.5 m.

  • Facade offset: how far out from the wall Giraffe measures each facade piece. The default is 0.3 m.

  • Full detail in Lost mode: the Lost colors trace building surfaces at the same detail as Hours. Turn it off on a computer with low-end graphics to use half the graphics memory.

Accuracy, the time window, and Color by are saved in your browser for each project. Each teammate sets their own.

Did this answer your question?