Reading a site's slope is the first step in planning where buildings, roads, and drainage go. The Display group in the Terrain app controls what Giraffe draws on the terrain: contour lines, cut and fill colors, drainage arrows, and shading. Each setting has a checkbox, and many have a value beside it. Display settings are saved with the project, so everyone sees the terrain the same way.
Cut and fill colors
Turn on Cut and fill colors to color the terrain by how much each pad or ramp cuts or fills it. The value beside it sets how strong the colors are, from 0% to 100%. It is on by default at 60%.
Contours
Turn on Contours to draw contour lines on the terrain. The value beside it sets the height between lines, from 0.1 to 100 m. Contours are on by default, 2 m apart.
Major contours
Turn on Major contours to draw every few contour lines heavier, so heights are easier to count. The value beside it sets the height between major lines, usually a multiple of the contour interval. It starts at five times the contour interval, which is 10 m by default. Major contours need Contours on.
Original contours
Turn on Original contours to draw the contours of the ground before cut and fill in grey. Compare them with the current contours to see how far the ground has moved. Original contours need Contours on.
Level at cursor
Turn on Level at cursor to highlight the contour at the height under the cursor. Use it to see what else on the site sits at that level, such as where a pad level meets the existing ground. A tag beside the cursor shows the level, such as "Level 42.50 m". The highlight shows while the Terrain app is open on screen. Level at cursor is saved in your browser.
Fall arrows
Turn on Fall arrows to draw arrows that show which way the ground drains. Arrows are longer where the ground is steeper. Amber rings mark ground flatter than 0.5%, which is too flat to drain. The value beside it sets the spacing between arrows, from 1 to 50 m. It starts at 6 m.
Relief shading
Turn on Relief shading to shade slopes, so the shape of the terrain is easier to read.
Plain background
Turn on Plain background to hide the basemap on the terrain, so contours and colors stand out. Click the color beside it to change the background's color and opacity. The background starts white.
Clip to boundary
Turn on Clip to boundary to draw contours, colors, and the plain background inside your project boundary only. It needs a polygon boundary. It turns on the first time you click 3D in a project.
Tile buffer
Tile buffer loads more terrain beyond your project boundary, up to 500 m. Raise it when the terrain stops short of the area you need to see. Higher values can slow Giraffe down. When your project boundary is a point, Giraffe loads terrain 500 m around the point, and the tile buffer adds to that.
Feature offset
Feature offset raises or lowers your geometries relative to the terrain, by up to 5 m either way. Use it when geometries sit slightly into or above the ground.
Show terrain tile boundaries
Hover over the info icon at the top of the Terrain app to see where the terrain data comes from. Click Show/hide tile boundaries in that box to draw the edges of each terrain tile on the map.




