Following these steps ensures your labels print clearly, align correctly, and avoid common printing issues.
1. Install and Run QZ Tray (Required)
Before setting up your printer, make sure QZ Tray is installed and running.
QZ Tray is required for AccelerList to communicate with your printer.
Install QZ Tray
Open it and make sure it is running in the menu bar (top right)
Refresh AccelerList after opening
👉 If QZ Tray is not running, printing will not work
To guide you about QZ Tray, kindly click the button below:
2. Open AccelerList in Chrome (Recommended)
Close the AccelerList desktop app (if open)
Open Google Chrome
Log in to AccelerList
Using Chrome helps ensure proper communication with QZ Tray.
3. Open Printer Settings in AccelerList
Navigate to:
Settings → Printer → SKU + FNSKU Labels
4. Configure Printer Settings in AccelerList
Set the following:
Active Printer: Brother QL-800 / QL-700
Printer Driver Config: Select available Brother config
Orientation: (depends on label, usually Portrait)
Label Type: 30252 (or any label size that matches 30252 dimensions)
✅ Click Save Changes
5. Set Printer as Default (Mac)
Go to System Settings → Printers & Scanners
Select your Brother printer
Set it as the default printer
This helps AccelerList and QZ Tray detect the correct printer.
6. Connect AccelerList to QZ Tray
In AccelerList, open printer settings
Select your printer
When prompted, click Allow / Trust
This ensures your browser can send print jobs.
7. Select Printer Driver Config
Choose a Printer Driver Config from the dropdown
Click Save
⚠️ If no driver config is selected, printing may fail or do nothing
8. Verify Label Size in Printer Settings
Make sure your label roll matches 30252 (or equivalent size)
Avoid using custom sizes if a preset is available
Using presets ensures better alignment and reliability.
9. Print a Test Label
Click Print Test Label in AccelerList
Confirm:
Label is aligned
Not cut off
Prints clearly
10. Troubleshooting (If Test Print Fails)
If printing does not work:
Restart QZ Tray and refresh AccelerList
Confirm printer is still set as default
Recheck Driver Config + Label Size
Try another preset label size
Restart your Mac if needed
Quick Reminder ✅
For best results:
Use Brother QL-800 / QL-700 printer
Use 30252 label size (or matching dimensions)
Ensure QZ Tray is installed and running
Use Google Chrome
Select a valid Printer Driver Config
Avoid manual/custom label sizes when possible
If everything is set correctly, your SKU + FNSKU labels should print clean, properly aligned, and ready to use 👍