Get jmc running: Part two

The second step in getting jmc running is to convert folders to applications.

jmc training avatar
Written by jmc training
Updated over a week ago

You're almost there. We have to initiate the different jmc applications here.

Step One: Click on the "+" next to "Sites" in the upper left corner.

Step Two: Click on the "+" next to "Default Web Site" below that.

Step Three: Right-click each folder one at a time and choose "Convert to Application".

Step Four: Click on "Select..." to the right.

Step Five: Choose the corresponding "Application Pool" name in the list and click "OK".

Step Six: Click "Connect as...", then "Specific user", and then "Set...".

Step Seven: Enter the "webjmc" username and password and then click "OK".

Helpful Tip: Back on the "Connect As..." screen, click "OK". When you are back at the "Add Application" screen, click on "Test Settings...". You should get a message stating the test was successful. Click "Close".

Step Eight: Click "OK". 

Helpful Tip: Repeat steps three through eight for each of the jmc folders.

Did this answer your question?