The collar, or "blocker", is a spare part we're currently sending:
Inside the packaging box for orders past August 1st, 2024
through our customer support team if your order is before this date
2 types of collars exist:
Removable blocker or blocker as a spare part. This blocker is meant to be set directly on the tail of Perifit Care+ and can be removed.
Screwable blocker. This blocker is fixed on the tail of the Perifit Care+ and cannot be removed.
Removable collar
The removable collar can easily be assembled onto the tail of your Perifit Care+ to keep it in place during your training sessions.
You can use your Perifit+ without it; however, consider using this collar if:
you're experiencing difficulties with calibration during a session;
you're experiencing important contraction quality or strength variations;
you feel that the Perifit+ is moving inside your vagina during your training;
Here is a step-by-step instructions on how to place it properly:
Insert the collar on the tail so that the lotus is at the bottom but points upwards, towards the part of the tail furthest from the Perifit Care+.
Push the collar on the tail. Slide it as close as possible to the lower pebble-shaped sensor.
Finally, check that the ring slot is fully inserted into the tail
Now that it's set up, you can:
Insert Perifit Care+ so that both pebble-shaped sensors are inside the vagina, with the lowest one on the probe near the vaginal entrance.
Once inserted, the collar should be snugged between your labia, meaning it's inserted as far as possible without entering the vagina.
Just so you know, depending on your anatomy, the exact placement of the collar on the tail can vary.
Based on that, you can adjust the collar and see what position gets you the best results.
To take the collar out, just:
Take out Perifit Care+ by pulling gently on the tail
Gently take out the collar from the tail
If you have any questions, please don’t hesitate to reach out to our support team from within the app.
Screwable blocker
The screwable collar is already assembled onto the tail of your Perifit Care+ to keep it in place during your training sessions. It's fixed and cannot be removed.
⚠️ Do not try to remove it as it might damage the silicon.
To insert Perifit Care+, you can:
Insert Perifit Care+ so that both pebble-shaped sensors are inside the vagina, with the lowest one on the probe near the vaginal entrance.
Once inserted, the collar (blocker) should be snugged between your labia, meaning it's inserted as far as possible without entering the vagina.
To take Perifit Care+ out, just pull gently on the tail until the device is out of your vagina.
If you have any questions, please don’t hesitate to reach out to our support team from within the app.