It can easily be assembled onto the tail of your Perifit+ to keep it in place during your training sessions.
You can use your Perifit+ without it; however, consider using this silicon ring if:
you're experiencing difficulties with calibration during a session;
you're experiencing important contraction quality or strength variations;
you feel that the Perifit+ is moving inside your vagina during your training;
Here is a step-by-step instructions on how to place it properly:
Push the silicon ring all the way onto the tail
Slide it as close as possible to the lower pebble-shaped sensor
Finally, check that the ring slot is fully inserted into the tail
Attached to this article is a short video if you're struggling to visualise what we describe.
Note that depending on your anatomy, the exact placement of the ring on the tail can vary.
The important is that both pebble-shaped sensors are inside the vagina, with the lowest one on the probe near the vaginal entrance.
Based on that, you can adjust the silicon ring and see what position gets you the best results.
If you have any questions, please don’t hesitate to reach out to our support team from within the app.