Step 1: Connect the USB cable between the computer and the mini-USB port on the control panel.

Step 2: Open a browser and log in to the local web interface at http://192.168.7.2:

Step 3: Go to Configuration in the left-hand menu, open the Setup tab and select Advanced settings.

Step 4: Open the Interface tab and set the WAN dropdown to Wired.

Step 5: Set Configuration Method to DHCP. If your router does not support DHCP, enter the network settings manually. Click Save.

Step 6: In Authorization Settings, check the following charge point settings and click Save:

Step 7: On the General tab, enable RFID and click Save. This is required for the connection with EEVEE to work.

Step 8: Under Outlets, set the authentication mode to RFID. If it shows "Open", change it to RFID and click Save.

Step 9: Check the status page to confirm that internet access works.

Step 10: Go to Configuration > Backend:

Save at the bottom of the page and reset the charging station.

Step 11: On the status page, check that the Backend connection and WAN Connection are established.

Step 12 (installers): Activate the charging station on the EEVEE platform: (TBD)

Step 13 (owners): Register the charging station in your EEVEE account: (TBD)

The charging station is now linked to your EEVEE account!