Configuration requirements
Configuration package (SIM card (optional), EVSE-ID, configuration guide for the installer, registration guide for the charging station owner)
Power Electronics installation guide
Configuration device: laptop or mobile phone
Connectivity: Ethernet cable, Wi-Fi hotspot or 3G/4G SIM card
Follow the steps
Step 1: Follow the Power Electronics installation manual to complete the installation safely.
Step 2: Put your configuration device on the same network as the charging station. You can do this with:
A 3G/4G SIM card
The factory-enabled Wi-Fi access point (hotspot)
An external Wi-Fi network
An Ethernet cable connected to the port inside the equipment
Step 3: Enter 192.168.204.10 in your browser, then enter the username and password of the charging station to log in to the web server.
Step 4: Click the webmanager tab at the top of the screen.
Step 5: Open the set up menu and click the communications button at the top.
Step 6: Configure the network settings for your connection method:
SIM 3G/4G:
APN: if the charging station uses a SIM card, APN: (TBD)
User: leave empty
Password: leave empty
PIN: disable
Wi-Fi:
Enable Wi-Fi: turn Wi-Fi on or off
Network type: the type of network to connect to
Hidden network: turn on to connect to a network with a hidden SSID
SSID: the network name
Password: the network password
Ethernet:
Enable single IP: turn on or off the use of a unique IP for accessing the equipment
DHCP: when enabled, the IP is assigned automatically. When disabled, you can set the IP address, gateway, netmask, primary DNS and secondary DNS manually.
The SIM settings only apply if a SIM card is inserted.
Step 7: Configure the OCPP settings:
WebSocket URL:
wss://eevee-hvpq.powerfill.app/ws/serialnumber(replace serialnumber with the serial number of the charging station)Enabled OCPP:
EnableTimeout WebSocket:
120Notify charger status:
EnableWebSocketPingInterval:
60Occupy logical connector:
Disable
Step 8: Click apply, then reset the charging station in the system menu.
If you are the installer, continue to Step 9. If you are the owner of the charging station, continue to Step 10.
Step 9 (installers): Activate the charging station on the EEVEE platform: (TBD)
Step 10 (owners): Register the charging station in your EEVEE account: (TBD)
The charging station is now linked to your EEVEE account!