This guide applies to the Vega ALOHA Lander charger.
Configuration requirements
EEVEE configuration package, containing an optional SIM card, the EVSE ID, an installer configuration manual and an owner registration manual
ALOHA Lander installation manual
A service laptop
An Ethernet cable
Follow the steps
Important: Follow the ALOHA Lander installation manual for safe installation procedures.
Step 1: Insert the SIM card.
Switch off the power to the charger.
Open the door and locate the modem (PCB A5, marked with a SIM icon).
Insert the SIM card with the flat corner at the bottom right until it is fully seated.
Step 2: Connect the laptop to the charger.
Make sure no vehicles are charging.
Open the front door.
Connect the Ethernet cable from the laptop to the Ethernet port next to the USB port on the A7 PCB, just behind the HMI screen.
Step 3: Set a fixed IP address on the laptop. The Ethernet IP address of the charger is 192.168.1.100. Set the laptop to IP address 192.168.1.50 with subnet mask 255.255.255.0.
Windows: Control Panel > Network and Internet (view by Category) > Network and Sharing Center > Change adapter settings > open the Ethernet adapter > Networking tab > TCP/IPv4 > enter the IP address and subnet mask, then confirm when closing.
Mac: System Preferences > Network > Ethernet > Advanced > TCP/IP > set Configure IPv4 to
Manually, enter the IP address and subnet mask > Apply, and check that the Ethernet dot is green.
Step 4: Open a browser and go to the embedded web server at http://192.168.1.100:8585.
Step 5: On the Authentication page, enable user authentication and select the OCPP-RFID option. Disable autocharge so users must authenticate (app, RFID tag or another method) to start a session.
Step 6: On the Connectivity page, choose the connection type:
Ethernet: LAN connection to the central system
Cellular: LTE (4G) connection to the central system
If the charging station uses a SIM card, set the following in the Cellular menu:
SIM PIN: (TBD)
APN login: (TBD)
APN: (TBD)
Step 7: On the OCPP Settings page, fill in:
Central system endpoint:
wss://eevee-hvpq.powerfill.app/ws/Charge box ID: the unique serial number of the charger (found on the System information page)
Step 8: Click "apply and reboot" at the top right to save. Installers continue to Step 9. Owners continue to Step 10.
Step 9 (installers): Activate the charging station on the EEVEE platform: (TBD)
Step 10 (owners): Register the charging station in your EEVEE account: (TBD)
The charging station is now linked to your EEVEE account!