Configuration requirements

EEVEE configuration package, containing:
- SIM card (optional)
- EVSE-ID
- Configuration guide for the installer
- Registration guide for the owner of the charging station
Witty Park 2 installation manual
Configuration device: laptop

Follow the steps

Step 1: Activate the Wi-Fi hotspot by holding the RFID tag against the reader for at least 7 seconds. A blue LED confirms the activation.

Step 2: Connect your laptop to the Wi-Fi network named Witty-xxxxxx, where xxxxxx are the last 6 digits of the serial number.

Step 3: Open the web interface by entering the IP address 192.168.3.5 or the host name Hager.local in your browser.

Step 4: Log in:

Username: admin
Password: the first 4 digits of the serial number, shown on the label on the side of the charging station.

Step 5: Go to the Charging station tab, select Network and set up your connection method.

If the charging station uses a SIM card, enable mobile data in the network settings and enter the APN: (TBD)

Step 6: Go to the Access management tab, select Access methods and enable Controlled access.

Step 7: Select Charging point operator and enter the following:

If you are the installer, continue with Step 8. If you are the owner, continue with Step 9.

Step 8 (installers): Activate the charging station on the EEVEE platform: (TBD)

Step 9 (owners): Register the charging station in your EEVEE account: (TBD)

The charging station is now linked to your EEVEE account!