Configuration requirements
EEVEE configuration package, containing:
EVSE-ID
Configuration guide for the installer
Registration guide for the owner of the charging station
Witty Plus installation manual
Hager Charge app
Configuration device: mobile phone
Follow the steps
Step 1: Download the free Hager Charge app.
Step 2: Pair the charging station:
Open the app.
Accept the terms of use.
Tap Next.
Enable Bluetooth.
Tap Start pairing.
Hold the pairing badge against the front of the charging station.
Remove the badge when the indicator on the front panel blinks blue from left to right (about 7 seconds).
Confirm in the app. The app scans and shows the device it found.
Enter a device name (optional).
Tap Pair with this charging station.
Confirm by tapping Pair.
Step 3: Go to Charging station settings and select General parameters. Make sure Installer mode is enabled (top right).
Step 4: In General parameters, open Network settings and choose the network type: WIFI or Wired.
Step 5: Go back to General settings and select CPO configuration.
Step 6: Enter the connection parameters:
Operator address:
wss://eevee-hvpq.powerfill.app/ws/OCPP ID: enter the ChargeBoxSerialNumber
Authentication type:
None
Step 7: Tap Save.
If you are the installer, continue with Step 8. If you are the owner, continue with Step 9.
Step 8 (installers): Activate the charging station on the EEVEE platform: (TBD)
Step 9 (owners): Register the charging station in your EEVEE account: (TBD)
The charging station is now linked to your EEVEE account!