Configuration requirements

Configuration package (SIM card (optional), EVSE-ID, configuration guide for the installer, registration guide for the charging station owner)
Cable (supplied with the charging station)
Configuration device: laptop or mobile phone
Mennekes installation manuals for AMTRON Professional and AMEDIO Professional

Follow the steps

Step 1: Connect to the web interface using one of these three methods:

USB: connect via USB cable and open 192.168.123.123 in your browser.
Ethernet: connect via Ethernet cable and set your PC network to a fixed IPv4 address (IP address 192.168.124.21, subnet mask 255.255.255.0, gateway 192.168.124.1). Then open 192.168.124.123 in your browser.
Network: connect the charging station to the network via Ethernet and put your PC on the same network. Open the IP address of the charging station in your browser.

Step 2: Log in with username operator. The password can be found on the data sheet supplied with the charging station.

Each socket has its own password for the web interface.

Step 3: Go to Netwerk (Network) and configure the GSM and LAN settings:

Step 4: Save the network settings.

Step 5: Go to the backend settings and set the following:

Connection type: GSM or Ethernet
OCPP ChargeBoxIdentity: the serial number of the charging station, or the EVSE-ID if you have received one
OCPP mode: OCPP-J 1.6
Websocket URL: wss://eevee-hvpq.powerfill.app/ws/
Leave all other settings unchanged.

Step 6: Save the settings and reset the charging station.

If you are the installer, continue to Step 7. If you are the owner of the charging station, continue to Step 8.

Step 7 (installers): Activate the charging station on the EEVEE platform: (TBD)

Step 8 (owners): Register the charging station in your EEVEE account: (TBD)

The charging station is now linked to your EEVEE account!