Configuration requirements

EEVEE configuration package, containing an optional SIM card, the EVSE ID, an installer configuration manual and an owner registration manual
AC SMART ECO, VALUE & ADVANCED installation manual
A laptop
An Ethernet cable

The same steps apply when migrating an existing charger.

Follow the steps

Step 1: Connect the charger to the local network with a LAN cable, following chapter 9.1 of the installation manual.

Step 2: On the laptop, press Win+R and enter ncpa.cpl to open the network connections.

Step 3: Right-click the Ethernet adapter and open its properties.

Step 4: Select internet protocol version 4 (TCP/IPv4) and open its properties.

Step 5: Set a static IP address on the laptop:

IP address: any value from 192.168.0.2 to 192.168.0.254, except 192.168.0.8, which is used by the charger
Subnet mask: 255.255.255.0
Confirm with OK.

Step 6: Open the web interface of the charger at http://192.168.0.8 and log in with:

Step 7: Go to network/Cloud, enable OCPP 1.6J, select the interface and configure its network settings. Then fill in:

Portal address: eevee-hvpq.powerfill.app
Portal port: 443
Portal path: /ws/ChargeBoxSerialNumber, where ChargeBoxSerialNumber is replaced with the unique serial number of the charger
Secure connection (TLS/wss): ON
APN name (if the charging station uses a SIM card): (TBD)

Step 8: Save and reboot the charger. Installers continue to Step 9. Owners continue to Step 10.

Step 9 (installers): Activate the charging station on the EEVEE platform: (TBD)

Step 10 (owners): Register the charging station in your EEVEE account: (TBD)

The charging station is now linked to your EEVEE account!