Skip to main content

Honeywell Motion - Loss of Supervision

Discover how to troubleshoot and resolve loss of supervision issues with Honeywell motion detectors

Written by Ivan Lara

Instructions:

  1. Ensure the panel is disarmed.

  2. Open the sensor by depressing the tab on the bottom and lifting the sensor off its mounting bracket.

  3. Remove the old battery.

  4. Wait 15–20 seconds.

  5. Install a replacement CR-123A battery.

  6. Close the sensor by sliding the top into the mounting bracket, then swinging the sensor down and clicking the bottom into place.

  7. Check the panel to see if the error has cleared.

If the error persists, please call our Account Specialists for further assistance

CA (587) 844-5377 | US (385) 832-9055


​

Did this answer your question?

Related Articles