IQ Panel 4
Ensure the panel is disarmed.
Swipe down from the top of the screen to access the Settings tray.
Press Settings.
Press Advanced Settings.
Enter the master code.
Press Sensor Test.
Review the results and connection strength for senser on the testing screen.
Exit out from the results by tapping the X in the top right corner.
2GIG GC3
Ensure the panel is disarmed.
Press System Settings.
Enter the 4-digit master code.
Press System Tests.
Press Sensors Test.
Trigger the sensor
Door - Open/Close the door
Window - Open/Close the window
Motion - Walk past the motion detector
Glass Break - Press the Test button for 5 seconds, then release
Smoke - Press and hold the Test button for 15 seconds
Carbon - Press and hold the Test button for 15 seconds
Flood - Use a damp cloth to get the prongs on the bottom of the sensor wet
Press the Back arrow 3 times to end the test.
2GIG GC2
At the Home screen, tap Security.
At the Security screen, tap Menu.
Select Toolbox.
Enter the 4-digit master code.
At the Toolbox (1 of 3) screen, tap System Test.
At the System Test: Sensors screen, a list of sensors appears. Use the ↑ and ↓arrows to scroll through the list. TIP: When a red bar is displayed for a sensor, the test has failed.
Go to each sensor listed, and trigger it.
For door or window sensors, open and close the door or window.
For motion detectors, stay out of the protected area for five (5) minutes, then walk through the area.
For portable sensors and wireless keypads, tap a button.
For smoke, CO, or glass break detectors, tap the detector’s test button.
When all sensors have been tested, tap OK. Then continue with the Panel Test.
Tap each button in the list. Then tap Yes or No to respond to the test question.
After answering all of the questions, tap OK.
At the System Test Successful screen, tap OK.
If the error persists, please call our Account Specialists for further assistance
CA (587) 844-5377 | US (385) 832-9055